0
RESEARCH PAPERS

Effect of Blade Tip Configuration on Tip Clearance Loss of a Centrifugal Impeller

[+] Author and Article Information
M. Ishida, H. Ueki

Faculty of Engineering, Nagasaki University, Nagasaki 852, Japan

Y. Senoo

Miura Company, Matsuyama, 799-26, Japan

J. Turbomach 112(1), 14-18 (Jan 01, 1990) (5 pages) doi:10.1115/1.2927412 History: Received January 17, 1989; Online June 09, 2008

Abstract

According to the theory presented by the authors, the tip clearance loss of an un-shrouded centrifugal impeller mainly consists of two kinds of loss; one is the drag due to the leakage flow through the blade tip clearance and the other is the pressure loss to support the fluid in the thin annular clearance space between the shroud and the blade tip against the pressure gradient in the meridional plane without blades. The former is proportional to the leakage flow or the contraction coefficient of leakage flow. The authors have conducted performance tests using an impeller with 16 backward-leaning blades in three configurations of the blade tip: round edge, sharp square edge, and edge with an end-plate. The experimental tip clearance effects can be predicted by the theory assuming reasonable contraction coefficients. They are 0.91, 0.73, and 0.53 for the respective tip configurations. The impeller efficiency is improved by about 1.5 point by reducing the contraction coefficient from 0.91 to 0.53, providing that the tip clearance ratio at the exit of impeller is 0.1. More improvement is expected for an impeller with highly loaded blades where the leakage loss shares the major part of the tip clearance loss.

Copyright © 1990 by The American Society of Mechanical Engineers
Your Session has timed out. Please sign back in to continue.

References

Figures

Tables

Errata

Discussions

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In