0
RESEARCH PAPERS

Velocity and Temperature Profiles for Stagnation Film Cooling

[+] Author and Article Information
R. E. Mayle, A. Anderson

Department of Mechanical Engineering, Rensselaer Polytechnic Institute, Troy, NY 12180

J. Turbomach 113(3), 457-463 (Jul 01, 1991) (7 pages) doi:10.1115/1.2927896 History: Received December 01, 1990; Online June 09, 2008

Abstract

Experiments were conducted for film cooling through rows of slanted holes into the stagnation region of a two-dimensional blunt body with a circular leading edge. The rows were located at ± 15 deg +44 deg from stagnation. The holes in each row were spaced four hole diameters apart and were angled 30 deg to the surface in the spanwise direction. Detailed velocity and temperature measurements were obtained downstream of injection. Measurements were taken for three secondary-to-incident flow mass flux ratios at various streamwise and spanwise positions. The results show large initial spanwise variations and indicate that the injected secondary flow at high mass flux ratios actually leaves the surface. In addition, it was found that the aerodynamic loss caused by injection increases linearly with the mass injected and that for a given hole pattern, there is an optimum blowing rate at which the injected fluid from one row of holes does not interfere with that from the other.

Copyright © 1991 by The American Society of Mechanical Engineers
Your Session has timed out. Please sign back in to continue.

References

Figures

Tables

Errata

Discussions

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In