0
RESEARCH PAPERS

Influence of High Mainstream Turbulence on Leading Edge Film Cooling Heat Transfer

[+] Author and Article Information
A. B. Mehendale, J. C. Han

Turbine Heat Transfer Laboratory, Mechanical Engineering Department, Texas A&M University, College Station, TX 77843

J. Turbomach 114(4), 707-715 (Oct 01, 1992) (9 pages) doi:10.1115/1.2928023 History: Received January 05, 1991; Online June 09, 2008

Abstract

The influence of high mainstream turbulence on leading edge film effectiveness and heat transfer coefficient was studied. High mainstream turbulence was produced by a passive grid and a jet grid. Experiments were performed using a blunt body with a semicylinder leading edge with a flat afterbody. The mainstream Reynolds number based on leading edge diameter was about 100,000. Spanwise and streamwise distributions of film effectiveness and heat transfer coefficient in the leading edge and on the flat sidewall were obtained for three blowing ratios, through rows of holes located at ±15 and ±40 deg from stagnation. The holes in each row were spaced three hole diameters apart and were angled 30 and 90 deg to the surface in the spanwise and streamwise directions, respectively. The results indicate that the film effectiveness decreases with increasing blowing ratio, but the reverse is true for the heat transfer coefficient. The leading edge film effectiveness for low blowing ratio (B = 0.4) is significantly reduced by high mainstream turbulence (Tu = 9.67 and 12.9 percent). The mainstream turbulence effect is diminished in the leading edge for higher blowing ratios (B = 0.8 and 1.2) but still exists on the flat sidewall region. Also, the leading edge heat transfer coefficient for blowing ratio of 0.8 increases with increasing mainstream turbulence; but the effect for other blowing ratios [B = 0.4 and 1.2) is not as systematic as for B = 0.8. Surface heat load is significantly reduced with leading edge film cooling.

Copyright © 1992 by The American Society of Mechanical Engineers
Your Session has timed out. Please sign back in to continue.

References

Figures

Tables

Errata

Discussions

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In