Darryl E. Metzger Memorial Session Paper: The Influence of Secondary Flows Near the Endwall and Boundary Layer Disturbance on Convective Transport From a Turbine Blade

[+] Author and Article Information
R. J. Goldstein, H. P. Wang, M. Y. Jabbari

Department of Mechanical Engineering, University of Minnesota, Minneapolis, MN 55455

J. Turbomach 117(4), 657-665 (Oct 01, 1995) (9 pages) doi:10.1115/1.2836585 History: Received February 15, 1994; Online January 29, 2008


A naphthalene sublimation technique is used to investigate convective transport from a simulated turbine blade in a stationary linear cascade. In some of the tests undertaken, a trip wire is stretched along the span of the blade near the leading edge. The disturbance produced by tripping the boundary layers on the blade near the leading edge causes early boundary layer transition, creates high mass transfer rate on the pressure side and in the laminar flow region on the suction side, but lowers the transfer rate in the turbulent flow region on the suction side. Comparison is made with other heat and mass transfer studies in the two-dimensional region far from the endwall and good agreement is found. Near the endwall, flow visualization indicates a strong secondary flow pattern. The impact of vortices initiated near the endwall on the laminar–turbulent transition extends three-dimensional effects to about 0.8 chord lengths on the suction side and to about 0.2 chord lengths on the pressure side away from the endwall. The effect of the passage vortex and the new vortex induced by the passage vortex on mass transfer is clearly seen and can be traced along the suction surface of the blade. Close to the endwall the highest mass transfer rate on the suction surface is not found near the leading edge. It occurs at about 27 percent of the curvilinear distance from the stagnation line to the trailing edge where a strong main flow and the secondary passage flow from the pressure side of the adjacent blade interact. The influences of some small but very intense corner vortices and the passage vortex on mass transfer are also observed on both surfaces of the blade.

Copyright © 1995 by The American Society of Mechanical Engineers
Your Session has timed out. Please sign back in to continue.






Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In