0
RESEARCH PAPERS

Row-of-Holes Film Cooling of Curved Walls at Low Injection Angles

[+] Author and Article Information
R. J. Goldstein, L. D. Stone

Heat Transfer Laboratory, Mechanical Engineering Department, University of Minnesota, 111 Church Street SE, Minneapolis, MN 55455

J. Turbomach 119(3), 574-579 (Jul 01, 1997) (6 pages) doi:10.1115/1.2841160 History: Received January 08, 1996; Online January 29, 2008

Abstract

Film cooling effectiveness data are presented against a backdrop of ammonia-diazo flow visualizations for row-of-holes injection along a convex wall and a concave wall at angles of 15, 25, and 45 deg to the mainstream and at density ratios of approximately one and two. Injection angle effects vary with the rate of injection: At low blowing rates the injection angle is unimportant, at moderate blowing rates the shallower angles provide better effectiveness, and at high blowing rates a steeper injection angle sometimes provides better effectiveness. The condition of the local boundary layer, the severity of jet lift-off, and the strength of vortex interactions among the bound vortices of neighboring jets are key considerations in interpreting the data.

Copyright © 1997 by The American Society of Mechanical Engineers
Your Session has timed out. Please sign back in to continue.

References

Figures

Tables

Errata

Discussions

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In