Issue Section:
Technical Briefs
1.
Chow, L. C., Tilton, D. E., and Pais, M. R., 1989, “High Power Density Spray Cooling,” WRDC-TR-89-2082, Wright Laboratory, OH.
2.
Chandra, S., and Avedisian, C. T., 1991, “On the Collision of a Droplet With a Solid Surface,” Proc. R. Soc. Lond., pp. 15–41.
3.
Galloway
J. E.
Mudawar
I.
1993
, “CHF Mechanism in Flow Boiling From a Short Heated Wall—II; Theoretical CHF Model
,” Int. J. Heat Mass Transfer
, Vol. 36
, No. 10
, pp. 2527
–2540
.4.
Katto
Y.
Yokoya
S.
1988
, “Critical Heat Flux on a Disk Heater Cooled by a Circular Jet of Saturated Liquid Impinging at the Center
,” Int. J. Heat Mass Transfer
, Vol. 31
, No. 2
, pp. 219
–227
.5.
Martin
H.
1977
, “Heat and Mass Transfer Between Impinging Gas Jets and Solid Surfaces
,” Advances in Heat Transfer
, Vol. 13
, pp. 1
–60
.6.
Mesler
R.
Pais
M. R.
Chow
L. C.
Mahefkey
E. T.
1993
, “Discussions on Surface Roughness and Its Effects on the Heat Transfer Mechanism in Spray Cooling
,” ASME JOURNAL OF HEAT TRANSFER
, Vol. 115
, pp. 1083
–1085
.7.
Pais, M. R., Tilton, D. E., Chow, L. C., and Mahefkey, E. T., 1989, “High Heat Flux, Low Superheat Evaporative Spray Cooling,” Paper No. AIAA-89-0241.
8.
Pais
M. R.
Chow
L. C.
Mahefkey
E. T.
1992
, “Surface Roughness and Its Effect on the Heat Transfer Mechanism in Spray Cooling
,” ASME JOURNAL OF HEAT TRANSFER
, Vol. 114
, pp. 211
–219
.9.
Pais
M. R.
Chow
L. C.
Mahefkey
E. T.
1993
, “Multiple Jet Impingement Cooling
,” J. Thermophysics Heat Transfer
, Vol. 7
, No. 3
, pp. 435
–440
.10.
Schlichting, H., 1980, Boundary Layer Theory, Chaps. 2 & 5, 6th ed., McGraw-Hill, New York.
11.
Sehmbey
M. S.
Pais
M. R.
Chow
L. C.
1992
, “Effect of Surface Material Properties and Surface Characteristics in Evaporative Spray Cooling
,” J. Thermophysics Heat Transfer
, Vol. 6
, No. 3
, pp. 505
–512
.12.
Tilton, D. E., 1989, “Spray Cooling,” PhD Dissertation, University of Kentucky, Lexington, KY.
13.
White, F. M., 1974, Viscous Fluid Flow, Chap. 3, McGraw-Hill.
14.
Yang
J.
Chow
L. C.
Pais
M. R.
1992
a, “Liquid Film Thickness and Topography Determination Using Fresnel Diffraction and Holography
,” Experimental Heat Transfer
, Vol. 5
, pp. 239
–252
.15.
Yang, J., Pais, M. R., and Chow, L. C., 1992b, “High Heat Flux Spray Cooling,” Proceedings of the SPIE, Invited Paper, High Heat Flux Engineering, SPIE Vol. 1739, San Diego, CA, pp. 29–40.
16.
Yang, J., 1993, “Spray Cooling With an Air Atomizing Nozzle,” PhD Dissertation, Dept. of Mechanical Engineering, University of Kentucky, Lexington, KY.
This content is only available via PDF.
Copyright © 1996
by The American Society of Mechanical Engineers
You do not currently have access to this content.
