In 1959, Akers et al. developed an in-tube condensation model, which defines the all-liquid flow rate that provides the same heat transfer coefficient as an annular condensing flow. This liquid flow rate was expressed by an “equivalent” Reynolds number and used in a single-phase, turbulent flow equation to predict the condensation coefficient. However, the assumptions on which the equivalent Reynolds number is based are shown in the present work to be faulty. This results in the underprediction of many researchers’ data. A new equivalent Reynolds number model, based on the heat-momentum analogy, is developed in this study. This model is then shown to predict the experimental Nusselt number of 1197 data points from 18 sources with an average deviation of 13.64 percent. The data are for tube internal diameters between 3.14 and 20 mm.
Issue Section:
Boiling and Condensation
Keywords:
Condensation
1.
Akers
W. W.
Deans
H. A.
Crosser
O. K.
1959
, “Condensing Heat Transfer Within Horizontal Tubes
,” Chemical Engineering Progress Symposium Series
, Vol. 55
, No. 29
, pp. 171
–176
.2.
Altman
M.
Staub
F. W.
Norris
R. H.
1960
, “Local Heat Transfer and Pressure Drop for Refrigerant-Condensing in Horizontal Tubes
,” Chemical Engineering Progress Symposium Series
, Vol. 56
, No. 30
, pp. 151
–159
.3.
Azer
N. Z.
Abis
L. V.
Swearingen
T. B.
1971
, “Local Heat Transfer Coefficients During Forced Convection Condensation Inside Horizontal Tubes
,” ASHRAE Transactions
, Vol. 77
, No. 1
, pp. 182
–201
.4.
Azer
N. Z.
Abis
L. V.
Soliman
H. M.
1972
, “Local Heat Transfer Coefficients During Annular Flow Condensation
,” ASHRAE Transactions
, Vol. 78
, No. 1
, pp. 135
–143
.5.
Bae, S., Maulbetsch, J. S., and Rohsenow, W. M., 1968, “Refrigerant Forced Convection Condensation Inside Horizontal Tubes,” Report No. 79760-59, Department of Mechanical Engineering, Heat Transfer Lab., MIT, Cambridge, MA.
6.
Bae, S., Maulbetsch, J. S., and Rohsenow, W. M., 1969, “Refrigerant Forced Convection Condensation Inside Horizontal Tubes,” Report No. 79760-64, Department of Mechanical Engineering, Heat Transfer Lab., MIT, Cambridge, MA.
7.
Bogart, J. E., 1996, personal communication, Wolverine Tube Inc., Decatur, AL.
8.
Baroczy
C. J.
1966
, “A Systematic Correlation for Two-Phase Pressure Drop
,” Chemical Engineering Progress Symposium
, Vol. 62
, No. 44
, pp. 232
–249
.9.
Boyko
L. D.
Kruzhilin
G. N.
1967
, “Heat Transfer and Hydraulic Resistance During Condensation of Steam in a Horizontal Tube and a Bundle of Tubes
,” International Journal of Heat and Mass Transfer
, Vol. 10
, pp. 361
–373
.10.
Carpenter, E. F., and Colburn, A. P., 1951, “The Effect of Vapor Velocity of Condensation Inside Tubes,” General Discussion on Heat Transfer, published by the Institute of Mechanical Engineers and ASME, pp. 20–26.
11.
Cavallini, A., and Zecchin, R., 1971, “High Velocity Condensation of Organic Refrigerants Inside Tubes,” Proc. Eighth International Congress of Refrigeration, Vol. 2, pp. 193–200.
12.
Cavallini, A., and Zecchin, R., 1974, “A Dimensionless Correlation for Heat Transfer in Forced Convection Condensation,” Proc. Fifth International Heat Transfer Conference, Vol. 3, pp. 309–313.
13.
Chisholm
D.
1973
, “Pressure Gradients Due to Friction During the Flow of Evaporating Two-Phase Mixtures in Smooth Tubes and Channels
,” Journal of Heat and Mass Transfer
, Vol. 16
, pp. 347
–358
.14.
Chitti
M. S.
Anand
N. K.
1995
, “An Analytical Model for Local Heat Transfer Coefficients for Forced Convective Condensation Inside Smooth Horizontal Tubes
,” International Journal of Heat and Mass Transfer
, Vol. 38
, No. 4
, pp. 615
–627
.15.
Chitti
M. S.
Anand
N. K.
1996
, “Condensation Heat Transfer Inside Smooth Horizontal Tubes for R- and R-32/125 Mixture
,” HVAC&R Research
, Vol. 2
, No. 1
, pp. 79
–100
.16.
Dobson
M. K.
1994
a, “Experimental Evaluation of Internal Condensation of Refrigerants R-12 and R-134a
,” ASHRAE Transactions
, Vol. 100
, No. 1
, pp. 744
–754
.17.
Dobson, M. K., et al., 1994b, “Heat Transfer and Flow Regimes During Condensation in Horizontal Tubes,” ACRC Technical Report 57, University of Illinois.
18.
Doerr
T. M.
Eckels
S. J.
Pate
M. B.
1994
, “In-Tube Condensation Heat Transfer of Refrigerant Mixtures
,” ASHRAE Transactions
, Vol. 100
, No. 2
, pp. 547
–555
.19.
Eckels
S. J.
Pate
M. B.
1991
, “Evaporation and Condensation of HFC-134a and CFC-12 in a Smooth Tube and a Microfin Tube
,” Alternative Refrigerants: ASHRAE Technical Data Bulletin
, Vol. 7
, No. 3
, pp. 10
–20
.20.
Eckels
S. J.
Doerr
T. B.
Pate
M. B.
1994
, “In-Tube Heat Transfer and Pressure Drop of R-134a and Ester Lubricant Mixtures in a Smooth Tube and a Micro-fin Tube: Part II—Condensation
,” ASHRAE Transactions
, Vol. 100
, No. 2
, pp. 283
–294
.21.
Friedel, L., 1979, “Improved Friction Pressure Drop Correlations for Horizontal and Vertical Two Phase Pipe Flow,” Paper E2, European Two Phase Flow Group Meeting, Ispra, Italy.
22.
Goodykoontz, J. H., and Brown, W. F., 1967, “Local Heat Transfer and Pressure Distributions for Freon-113 Condensing in Downward Flow in a Vertical Tube,” NASA TN D-3952.
23.
Hewitt, G. F., 1992, “Gas-Liquid Flow,” Handbook of Heat Exchanger Design, Begell House Inc., New York, pp. 2.3.2-9–2.3.2-12.
24.
Lockhart
R. W.
Martinelli
R. C.
1949
, “Proposed Correlation of Data for Isothermal Two-Phase, Two-Component Flow in Pipes
,” Chemical Engineering Progress
, Vol. 45
, No. 1
, pp. 39
–48
.25.
Moser, K. W., 1997, “A New Definition of the Equivalent Reynolds Number for Vapor Shear-Controlled Condensation Inside Smooth Tubes,” M.S. Thesis, The Pennsylvania State University.
26.
Petukhov, B. S., 1970, “Heat Transfer and Friction in Turbulent Pipe Flow With Variable Physical Properties,” Advances in Heat Transfer, Vol. 6, Academic Press, New York.
27.
Schlager
L. M.
Pate
M. B.
Bergles
A. E.
1989
, “Heat Transfer and Pressure Drop During Evaporation and Condensation of R in Horizontal Microfin Tubes
,” International Journal of Refrigeration
, Vol. 12
, pp. 6
–13
.28.
Schlager
L. M.
Pate
M. B.
Bergles
A. E.
1990
, “Evaporation and Condensation Heat Transfer and Pressure Drop in Horizontal, 12.7 mm Microfin Tubes With Refrigerant
,” ASME JOURNAL OF HEAT TRANSFER
, Vol. 112
, pp. 1041
–1047
.29.
Sieder
E. N.
Tate
C. E.
1936
, “Heat Transfer and Pressure Drop of Liquids in Tubes
,” Ind. Eng. Chem.
, Vol. 28
, pp. 1429
1429
.30.
Shah, M. M., 1979, “A General Correlation for Heat Transfer During Film Condensation Inside Pipes,” International Journal of Heat and Mass Transfer, Vol. pp. 547–556.
31.
Soliman
M.
Schuster
J. R.
Berenson
P. J.
1968
, “A General Heat Transfer Correlation for Annular Flow Condensation
,” ASME JOURNAL OF HEAT TRANSFER
, Vol. 90
, pp. 267
–276
.32.
Taitel, Y., and Dukler, A. E., 1976, “A Model for Predicting Flow Regime Transitions in Horizontal and Near Horizontal Gas-Liquid Flow,” American Institute of Chemical Engineering Journal, No. 1, pp. 47–55.
33.
Traviss, D. P., Baron, A. G., and Rohsenow, W. M., 1971, “Forced Convection Condensation Inside Tubes,” Report No. 72591-74, Department of Mechanical Engineering, Heat Transfer Lab., MIT, Cambridge, MA.
34.
Traviss
D. P.
Rohsenow
W. M.
Baron
A. B.
1973
, “Forced-Convection Condensation Inside Tubes: A Heat Transfer Equation for Condenser Design
,” ASHRAE Transactions
, Vol. 79
, No. 2
, pp. 31
–39
.35.
Wijaya
H.
Spatz
M. W.
1995
, “Two-Phase Flow Heat Transfer and Pressure Drop Characteristics of R- and R-32/125
,” ASHRAE Transactions
, Vol. 101
, No. 1
, pp. 1020
–1027
.
This content is only available via PDF.
Copyright © 1998
by The American Society of Mechanical Engineers
You do not currently have access to this content.
