The YawDyn computer code is used to calculate the aerodynamic damping for a typical teetering rotor configuration. The code has been modified to calculate the net work done by aerodynamic forces in one complete rotor revolution. All cases were run for a teetering rotor similar to the ESI-80 with a specified teeter angle motion in order to isolate the aerodynamic effects from the inertial and gravitational loads. Effects of nonlinear static stall, dynamic stall, dynamic inflow, and delayed static stall due to rotation are analyzed separately and in combinations to explain the stability of flap motions in high winds. Contributions of the various steady and unsteady aerodynamic effects are presented for two airfoils: the LS(1) and the NREL Thin Airfoil Family (S805A, S806, S807). Teeter stability is compared for a blade with 10 deg of linear twist and a blade with optimum aerodynamic twist.

Eggers, A. J., and Digumarthi, R. V., 1992, “Approximate Scaling of Rotational Effects of Mean Aerodynamic Moments and Power Generated by the Combined Experiment Rotor Blades Operating in Deep-Stalled Flow,” Eleventh ASME Wind Energy Symposium, Houston, TX.
Eggleston, D. M., and Stoddard, F. S., 1987, Wind Turbine Engineering Design, Van Nostrand Reinhold Company, New York.
Freris, L. L., 1990, Wind Energy Conversion Systems, Prentice-Hall, Englewood Cliffs, NJ.
Hansen, A. C., 1992, “Yaw Dynamics of Horizontal Axis Wind Turbines: Final Report,” National Renewable Energy Laboratory, NREL Technical Report, TP 442-4822.
Hansen, A. C., and Butterfield, C. P., 1993, “Aerodynamics of Horizontal-Axis Wind Turbines,” Annual Review of Fluid Mechanics, 1993, Annual Reviews, Inc., Palo Alto.
Laino, D. J., and Kelley, N., 1994, “YawDyn, Simulated Turbulence, and the Micon 65 Turbine,” unpublished draft internal report, National Renewable Energy Laboratory.
Pierce, K. G., and Hansen, A. C, 1993, “Prediction of Rotor Loads using the Beddoes-Leishman Dynamic Stall Model,” ASME Wind Energy Conference, Houston, TX.
D. M.
, and
D. A.
, “
Theoretical Predictions of Dynamic Inflow Derivatives
, Vol.
, No.
, pp.
Rasmussen, F., Petersen, J. T., Winkelaar, D., and Rawlinson-Smith, R., 1993, “Response of Stall Regulated Wind Turbines-Stall Induced Vibrations,” Riso̸ National Laboratory, Roskilde, Denmark, Riso̸-R-691(EN), June.
Snel, H., Houwink, R., Bosschers, J., Piers, W. J., van Bussel, G. J. W., et al. 1993, “Section Prediction of 3-D Effects for Stalled Flow on rotating Blades and Comparison with Measurements,” European Community Wind Energy Conference, Luebeck-Travemuende, Germany.
Tangler, J., Kelley, N. D., Jager, D., and Smith, B., 1994, “Measured Structural Loads for the Micon 65/13,” ASME Wind Energy Symposium, New Orleans.
Viterna, L. A., and Corrigan, R. D., 1981, “Fixed-Pitch Rotor Performance of Large HAWTs,” DOE/NASA Workshop on Large HAWTs, Cleveland, OH.
Wilson, R. E., and Lissaman, P. B. S., 1974, “Applied Aerodynamics of Wind Power Machines,” Oregon State University, NTIS PB 238594.
This content is only available via PDF.
You do not currently have access to this content.