Skip Nav Destination
Article navigation
Discussions
Closure to “Discussion of ‘Ways to Improve the Drilling Effectiveness of Rock Bits by a Tribological Method’” (1988, ASME J. Tribol., 110, p. 216)
Yi-Ling Wang,
Yi-Ling Wang
Shanghai Jiao Tong University, Shanghai, People’s Republic of China
Search for other works by this author on:
Hong Luo
Hong Luo
Shanghai Jiao Tong University, Shanghai, People’s Republic of China
Search for other works by this author on:
Yi-Ling Wang
Shanghai Jiao Tong University, Shanghai, People’s Republic of China
Hong Luo
Shanghai Jiao Tong University, Shanghai, People’s Republic of China
J. Tribol. Apr 1988, 110(2): 216 (1 pages)
Published Online: April 1, 1988
Article history
Online:
October 29, 2009
Connected Content
This is a commentary to:
Nonlinear Gross Response Analysis of a Lumbar Motion Segment in Combined Sagittal Loadings
Citation
Wang, Y., and Luo, H. (April 1, 1988). "Closure to “Discussion of ‘Ways to Improve the Drilling Effectiveness of Rock Bits by a Tribological Method’” (1988, ASME J. Tribol., 110, p. 216)." ASME. J. Tribol. April 1988; 110(2): 216. https://doi.org/10.1115/1.3261587
Download citation file:
104
Views
Get Email Alerts
Cited By
Enhanced Wear Volume Analysis Using Three-Dimensional Profilometry for Four-Ball Tribometer Setups
J. Tribol (September 2025)
Influence of Nano-Magnesium Silicate Hydroxide on Tribological Properties of Electroless Ni–P Coating
J. Tribol (November 2025)
Effects of Roller-End/Rib Geometrical Shape of Cylindrical Roller Bearings on Tribological Behavior
J. Tribol (November 2025)
Analytical Model of the Evolution of Surface Topography During Sliding Wear
J. Tribol (November 2025)
Related Articles
Modeling Flow of a Biviscous Fluid From Borehole Into Rock Fracture
J. Appl. Mech (January,2006)
Drilling Action of Roller-Cone Bits: Modeling and Experimental Validation
J. Energy Resour. Technol (December,2010)
Ways to Improve the Drilling Effectiveness of Rock Bits by a Tribological Method
J. Tribol (April,1988)
Related Proceedings Papers
Related Chapters
Fabrication of Single Crystal Diamonds∕Cemented Carbide Composite Cutter for Rock Drilling
Geological Engineering: Proceedings of the 1 st International Conference (ICGE 2007)
Introduction
Mechanics of Drillstrings and Marine Risers
Study and Construction of Experiment Table of Drilling at Any Position of Rock Sample
International Conference on Mechanical Engineering and Technology (ICMET-London 2011)